Borg-locks BL 7000 Easicode Change instructions Manuel d'utilisateur télécharger pdf (Page 2)

Whilst holding the code change cam at the 12o’clock position (as per fig.3) turn the handle

on the keypad side one full rotation (as per fig.4). When turning the handle a distinctive

click will be herd, this denotes that the keypad has been cleared of any set code.

To ensure all the set codes have been cleared from the unit rotate the handle 3-4 times,

each time the handle is rotated it should withdraw the latch bolt on the locking device.

With the handle at the horizontal position (as per fig.5) and the code change cam at

12o’clock (as per fig.3) a new code can be set to the keypad. Once you have decided what

you would like the unit coded to press the buttons that will be in the new code

Please note if you make a mistake when setting the new code turn the handle one full

rotation and this will clear any digits that has been set.

Now that all the digits in the code have been set into the keypad, the code change cam can

now be rotated back to the 9o’clock position (as per fig.2).

With the code change cam rotated back to the 9o’clock position (as per fig.2) the new code

can now be tested. Input the new code into the keypad and rotate the handle, if setting the

new code has been successful the latch bolt of the BL7000 will withdraw.

Ensure the keypad accepts the new code 3-4 times before closing the door and remember

to make a note of the new code.

Please call our helpline for spares, repairs and technical advice – 01708 225700

1 2

Pas de commentaire

Borg-locks BL 7000 Easicode Change instructions Manuel d'utilisateur Page 2